Control panel (fax/memory-card models)
1. Remove the control-panel bezel. See Control-panel bezel (fax/memory-card models)
on page 115.
2. Release one tab (callout 1) and then slide the control panel toward the left side of the product to
release it.
Figure 6-9 Remove the control-panel (1 of 2; fax/memory-card models)
1
3. Rotate the control panel up and off of the product, and then disconnect two FFCs (callout 2).
Figure 6-10 Remove the control-panel (2 of 2; fax/memory-card models)
2
Reinstall the control panel (fax/memory-card models)
1. Connect the FFCs and verify that they are fully seated.
116 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...