Transfer roller
1. Open the rear door.
2. Release the retainer clip and then rotate it until the pin on the clip aligns with the slot in the mounting
bracket.
Figure 6-17 Remove the transfer roller (1 of 3)
3. Remove the clip. Repeat these steps for the remaining retainer clip.
TIP: One of the clips is made from a black conductive plastic. Make sure that the clips are
reinstalled on the side of the transfer roller that they are removed from.
Figure 6-18 Remove the transfer roller (2 of 3)
122 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...