Front-right cover
NOTE: The fax/memory-card models have a memory-card reader PCA installed on this cover.
1. Remove the right cover. See Right cover on page 132.
2. Fax/memory-card models only: Remove two screws (callout 1), and then disconnect one FFC
(callout 2)
Figure 6-44 Remove the front-right (1 of 3)
1
2
3. Use a small flatblade screwdriver to release two tabs (callout 3).
Figure 6-45 Remove the front-right cover (2 of 3)
3
ENWW External panels, covers, and doors 137
To Next Page
Loading...