Internal assemblies
Print-cartridge drawer
1. Open the front door and out the print-cartridge drawer.
Figure 6-66 Remove the print-cartridge drawer (1 of 5)
2. Use a small flatblade screw driver to release one tab (callout 1) on the cartridge-drawer stop.
TIP: This clip slightly extends under the edge of the top cover (arrow). In the next step, you must
push in on the edge of the top cover to allow the clip to rotate away from the chassis
Figure 6-67 Remove the print-cartridge drawer (2 of 5)
1
ENWW Internal assemblies 151
To Next Page
Loading...