Fuser motor
1. Remove the following components:
●
Right cover. See
Right cover on page 132.
●
Formatter and fax card PCAs. See
Formatter and fax card PCAs on page 165.
2. Remove six screws (callout 1) and the sheet-metal plate.
NOTE: Base model: Remove four screws.
Figure 6-92 Remove the fuser motor (1 of 2)
1
3. Disconnect one wire-harness connector (callout 2) and then remove two screws (callout 3).
Remove the fuser motor.
Figure 6-93 Remove the fuser motor (2 of 2)
2
3
168 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...