Separation roller
CAUTION: Avoid touching the spongy roller surface unless you are going to replace the roller. Skin
oils on the roller can cause paper-pickup problems.
1. Remove the paper pickup roller. See Paper-pickup roller on page 85.
2. Remove Tray 2 (if installed), and then carefully raise the front of the product.
WARNING! Do not place the product face-up resting on the rear cover and rear door. Excess
toner might enter the laser/scanner assembly and contaminate the mirrors, causing print-quality
problems. The laser/scanner is not a FRU. If the laser/scanner mirrors are contaminated, the entire
product must be replaced.
CAUTION: Do not lift the product by grasping the front door and Tray 2 cavity.
Figure 6-6 Remove the separation roller (1 of 3)
ENWW Rollers and pads 87
To Next Page
Loading...