5. Before you proceed, look at Figure 6-132 Remove the fuser (4 of 8) on page 164. In the following
step, the connector and guide will be separated from the fuser. You must not use too much force
and damage the lower portion of the guide. If the guide is damaged, the fuser must be replaced.
Figure 6-132 Remove the fuser (4 of 8)
6. Carefully disconnect one connector and rotate the connector and the top portion of the guide away
from the fuser (callout 5).
WARNING! Do not separate the connector and guide more than is shown in Figure 6-132
Remove the fuser (4 of 8) on page 164. If the guide is damaged, you must replace the fuser.
Figure 6-133 Remove the fuser (5 of 8)
5
164 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...