NVRAM initialization
CAUTION: All HP Jetdirect settings are also reset. Be sure to print a configuration page before
performing an NVRAM initialization. Make note of the IP address that is listed on the Jetdirect
configuration page. You need to restore the IP address after performing an NVRAM initialization.
Performing an NVRAM initialization resets the following settings and information:
●
All menu settings are reset to factory default values.
●
All localization settings, including language and country/region, are reset.
After performing an NVRAM initialization, reconfigure any computers that print to this product so that
the computers can recognize the product.
Perform an NVRAM initialization
1. Turn the product off.
2. Simultaneously press the Right arrow
button and the X button. Keep these buttons depressed
as you turn the product on.
3. When Permanent storage init. appears on the display, release both buttons.
4. When the product has finished the NVRAM initialization, it returns to the Ready state.
ENWW Service mode functions 225
To Next Page
Loading...