Menu item Sub-menu item Sub-menu item Description
Calibrate color After power on
Calibrate now
After power on: Select how soon the
product will calibrate after you turn it on.
The default setting is 15 minutes.
Calibrate now: Makes the product
perform a calibration immediately. If a job
is processing, the product calibrates after
the job is complete. If an error message
is displayed, you must clear the error
first.
Cartridge low (1-20) The percentage threshold determines
when the product begins reporting low
toner. The message is either reported on
the control-panel display or using the
toner LED, if it exists.
Replace Supplies Override out
Stop at out
Override out: If the product determines
that a print cartridge has reached the end
of life, select this setting to continue
printing until there is a decrease in print
quality.
Stop at out: If the product determines
that a print cartridge is empty, the
cartridge must be replaced before
printing can continue. This is the default
setting.
Color Supply Out Stop Printing (default)
Continue Black
Stop Printing: If the product determines
that a color cartridges is empty, it stops
printing. This is the default setting.
Continue Black: If the product
determines that a color cartridges is
empty, continue printing using black
only.
Adjust Alignment Print Test Page
Adjust Tray <X>
Print Test Page: Print a test page that
tests printer alignment.
Adjust Tray <X>: Adjust the alignment
of the specified tray.
Display contrast Lightest
Lighter
Medium
Darker
Darkest
Select the level of contrast for the
display. The default setting is Medium.
18 Chapter 2 Control panel ENWW
To Next Page
Loading...