Print when cartridge is out
An Order Supplies message appears when a print cartridge is nearing the end of its life. A Replace
Supplies message appears when the print cartridge is depleted. To ensure optimal print quality,
HP recommends replacing a print cartridge when the Replace Supplies message displays. Print-quality
problems can occur when using a cartridge that is depleted, resulting in waste of print media and toner
from other cartridges. Replacing a print cartridge when the Replace Supplies message displays can
prevent this waste.
The Auto continue feature in HP ToolboxFX allows the product to continue using a print cartridge that
has reached the recommended replacement point.
WARNING! Using the Auto continue feature can result in unsatisfactory print quality.
WARNING! All print defects or supply failures incurred when an HP supply is used in cartridge-out-
override mode will not be considered to be defects in materials or workmanship in the supply under the
HP Print Cartridge Warranty Statement. For warranty information, see
Print cartridge limited warranty
statement on page 268.
You can enable or disable the Auto continue feature at any time, and you do not have to re-enable it
when you install a new print cartridge. When the Auto continue feature is turned on, the product
automatically continues printing when a print cartridge reaches the recommended replacement level. A
Replace Supplies Override In Use message displays while a print cartridge is being used in override
mode. When you replace the print cartridge with a new supply, the product deactivates the override
mode until another print cartridge reaches the recommended replacement level.
Enable or disable the Cartridge-out-override feature
1. Open HP ToolboxFX.
2. Click the Device Settings folder, and then click System Setup.
3. Next to Auto continue, select On to activate the feature. Select Off to make it unavailable.
Enable or disable the Cartridge-out-override feature from the control panel
1. On the control-panel menu, press OK.
2. Use the Left arrow (
) or the Right arrow ( ) button to select System setup, and then press
OK.
3. Use the Left arrow (
) or the Right arrow ( ) button to select Print quality, and then press OK.
4. Use the Left arrow (
) or the Right arrow ( ) button to select Replace Supplies, and then press
OK.
5. To activate the feature, select Override out. Select Stop at out to make it unavailable.
ENWW Manage supplies 45
To Next Page
Loading...