Load Tray 2 and optional Trays 3, 4, and 5 with standard-size
paper
1. Open the tray.
NOTE: Do not open the tray while it is in
use.
2. Adjust the paper-length and paper-width
guides by squeezing the adjustment latches
and sliding the guides to the size of the paper
being used.
3. Load paper into the tray. Check the paper to
verify the guides lightly touch the stack, but do
not bend it.
NOTE: To prevent jams, do not overfill the
tray. Be sure the top of the stack is below the
tray full indicator.
NOTE: If the tray is not adjusted correctly,
an error message might appear during
printing or the paper might jam.
92 Chapter 6 Paper and print media ENWW
To Next Page
Loading...
