Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv4 address, subnet mask, and default
gateway.
1. From the Home screen, scroll to and touch the Administration button.
2. Open each of the following menus:
a. Network Settings
b. Embedded Jetdirect Menu
c. TCP/IP
d. IPV4 Settings
e. Config Method
f. Manual
g. Manual Settings
h. IP Address, Subnet Mask, or Default Gateway
3. Use the keypad to specify the IP address, subnet mask, or default gateway.
ENWW
Connect to a network
79
To Next Page
Loading...
