Fuser
CAUTION: The fuser might be hot. Allow enough time after turning off the product power for the
fuser to cool.
1. Open the right-door assembly.
2. Grasp the handles and squeeze the blue release levers (callout 1).
Figure 5 Remove the fuser
2
1
3. Pull the fuser (callout 2) straight out of the product to remove it.
Reset the New Fuser Kit setting at the control panel
NOTE: Use this procedure to reset the internal page count if a replacement fuser is installed.
1. At the control panel, press the Home button .
2. Open the following menus:
●
Administration
●
Manage Supplies
●
Reset Supplies
●
New Fuser Kit
3. Use the Down arrow button
to highlight the Yes item, and then press OK to select it.
ENWW
Removal and replacement procedures
11
To Next Page
Loading...
