Figure 2-10 Open a command window
1
2
2. From any displayed directory, type telnet at the prompt, and then press the Enter key.
Figure 2-11 Start a telnet session
3. Type o <IP ADDRESS> at the telnet prompt, and then press the Enter key.
NOTE: For <IP ADDRESS>, substitute the IP address that was displayed in step 7 in Start the telnet
server function at the product on page 117.
TIP: If the telnet connection fails to establish a connection, the product is probably behind a firewall
or on a different network that the remote telnet client computer. See
Network connection on page 117.
Figure 2-12 Establish a telnet connection
120 Chapter 2 Solve problems ENWW
To Next Page
Loading...