Disconnect a remote connection
The Remote Admin connection can be terminated from the product control panel or the remote telnet client
computer.
NOTE: The following procedure describes terminating a Remote Admin connection from the remote telnet
client computer.
1. From the Pre-boot main menu, use the arrow buttons on the keybaord to scroll down to the
+3:Administrator item, and then press the Enter key.
Figure 2-15 Access the administrator menu
2. Use the arrow buttons on the keybaord to scroll down to the +A:Rmote Admin item, and then press the
Enter key.
Figure 2-16 Access the remote admin menu
3. Use the arrow buttons on the keybaord to scroll down to the 2:Stop Telnet item, and then press the
Enter key. The Remote Admin connection between the product and the remote telnet client computer
terminates.
IMPORTANT: The product remains in the Pre-boot menu. Have the person that is physically present at
the product do the following:
●
Touch the Home
button to return to the main Pre-boot menu and highlight the 1:Continue item,
and then touch the OK button. The product will continue to initialize.
122 Chapter 2 Solve problems ENWW
To Next Page
Loading...