Moving solenoid To exit press
Description
The solenoid is moving as part of a component test.
Recommended action
No action necessary.
To exit, press the Stop button
No job to cancel
Description
The user pressed the Stop button , but the product is not actively processing any jobs.
Recommended action
No action necessary.
Non HP Supply Installed
Description
A non-HP supply is detected.
This message displays for 30 seconds, and then the product returns to a Ready state.
The product does not provide supply status messages for non-HP supplies.
Recommended action
Press OK to continue.
If you believe you purchased a genuine HP supply, go to www.hp.com/go/anticounterfeit.
Output Bin Full
Description
The Output Bin Full message displays when the output bin is full and paper must be removed before printing
can continue.
Recommended action
1. Bin full is detected by sensor SR1 which is located under the top cover near the rear of the output bin
bezel. See the following figuresin this section.
404 Chapter 2 Solve problems ENWW
To Next Page
Loading...