Replace Fuser Kit
Description
The product indicates when the fuser kit is at its estimated end of life. The actual life remaining might be
different than the estimation. Have a replacement fuser kit available to install when print quality is no longer
acceptable.
The fuser kit does not need to be replaced now unless the print quality is no longer acceptable.
NOTE: After the fuser kit reaches its approximated end of life, the HP Premium Protection Warranty on that
fuser kit ends.
●
10.23.70 : (event code) Fuser Kit
Recommended action
Replace the fuser kit.
CAUTION: Use caution when handling the fuser. The fuser might be hot when the product is operating.
1. Open the right door.
2. Grasp the blue handles on both sides of the fuser and pull straight out to remove it.
3. Install the new fuser.
4. Close the right door.
Replace staple cartridge
Description
The staple cartridge is empty.
Recommended action
Replace the staple cartridge located in the stapler/stacker.
1. Open the left cover.
2. Remove the staple cartridge.
3. Install a new staple cartridge.
4. Close the left cover.
Replace Supplies
Description
At least two supplies on the product have reached the At very low condition and the user has set the Very
Low Settings menu item to Stop.
Recommended action
Press the OK button to see which supplies need to be replaced, or configure the product to continue printing
by using the Manage Supplies menu.
ENWW Tools for troubleshooting 415
To Next Page
Loading...