Table 2-66 Service menu (M651 and M680) (continued)
First level Second level Value Description
Cycle Counts Total Engine Cycles Set the page count that
was stored in NVRAM prior
to installing a new
formatter.
Mono Cycle Count Set the number of
monochrome print job
pages printed.
Color Cycle Count Set the number of color
print job pages printed.
Refurbish Cycle Count Use this item to record the
page count when the
product was refurbished.
Document Feeder Kit Count (M680) Total number of pages
since the document feeder
kit was replaced.
Document Feeder Kit Interval (M680) Use this item to set the
interval that causes the
product to prompt the
customer to replace
document feeder
maintenance kit.
Clean Roller Count (M680) Total number of pages
since the document feeder
rollers were cleaned.
Clean Roller Interval (M680) Use this item to set the
interval that causes the
product to prompt the
customer to clean the
document feeder rollers
and separation pad.
ADF Count (M680) Set the total pages fed
through the document
feeder.
Flatbed Count (M680) Set the total pages
scanned from the flatbed.
ADF Simplex Count (M680) Set the total single-sided
pages fed through the
document feeder.
ADF Duplex Count (M680) Set the total two-sided
pages fed through the
document feeder.
Copy Scan Count (M680) Set the total copy pages
that have been scanned.
Send Scan Count (M680) Set the number of
scanned pages sent to
email.
Fax Scan Count (M680) Set the number of
scanned pages that have
been faxed.
502 Chapter 2 Solve problems ENWW
To Next Page
Loading...