Table 2-66 Service menu (M651 and M680) (continued)
First level Second level Value Description
Cycle Counts
(continued)
Copy Pages Count (M680) Set the number of
scanned pages that have
been printed.
Duplex Feed Cycle Count Reset the number of
duplex pages that have
been printed.
Scanner Settings (M680) ADF Settings Leading-edge
Trailing-edge
Left Side Front
Left Side Back
Set the calibration values.
WARNING! Do not
change these values
unless instructed to do so.
Glass Settings Leading-edge
Glass
Left Side Glass
Set the calibration values.
WARNING! Do not
change these values
unless instructed to do so.
Serial Number Set the serial number.
Service ID Use this item to show the
date that the product was
first used on the control
panel. This eliminates the
need for users to keep
paper receipts for proof of
warranty.
Cold Reset Paper When a cold reset
executes, the paper size
that is stored in NVRAM is
reset to the default
factory setting. When
replacing a formatter
board in a country/region
that uses A4 as the
standard paper size, use
this menu to reset the
default paper size to A4.
LETTER and A4 are the
only available values.
New Registration Roller Yes
No
Set this item to Yes if the
registration assembly is
replaced.
Low Alerts Enable
Disable
Use this item to enable or
disable low alert
messages.
Reset Low Alerts Settings Reset Level 1
Reset Level 2
Reset Level 3
Set to non-HP
managed mode
ENWW Service mode functions 503
To Next Page
Loading...