Pickup roller, separation roller, and feed roller (Tray 3)
CAUTION: Do not touch the spongy roller surface unless you are replacing the roller. Skin oils on the
roller can cause paper pickup problems.
TIP: You do not have to separate the product from the feeder to remove these rollers.
1. Remove Tray 3 from the product, and then locate the Tray 3 rollers on the righthand side of the
tray cavity.
Figure 2-13 Remove the Tray 3 rollers (1 of 2)
2. Release three tabs, and then pull the rollers in the direction of the arrow.
Figure 2-14 Remove the Tray 3 rollers (2 of 2)
Reinstallation tip When you reinstall the rollers, make sure that the rollers snap into place.
ENWW Removal and replacement procedures 85
To Next Page
Loading...