HP Compaq 8200 Elite Series

HP 80-GB Solid State Drive
Unformatted Capacity 80-GB
Architecture Multi Level Cell (MLC) NAND Flash with wear leveling 10 channel controller
Interface Serial ATA 2.0 (3.0 Gb/s)
Dimensions (W x H x D) 2.74 x 0.37 x 4 in/6.98 x 0.95 x 10.2 cm
Weight 0.18 lb/80 g
Bandwidth Performance
Sustained Sequential Read: Up to 250 MB/s
Sustained Sequential Write: Up to 70 MB/s
Random Read: Up to 35K IOPs
Random Write: Up to 6.6K IOPs
Latency
Read: 65-ms
Write: 85-ms
Power
DC power requirement: 5 VDC 5%-100 mV ripple p-p
Total power consumption: 0.15W (active); 0.075W (idle)
Useful Drive Life 35TB written, up to 20GB/day for 5 years
Environmental
(all conditions, non-condensing)
Operating Temperature: 32° to 158° F (0° to 70° C)
Relative Humidity: 5% to 95%
Maximum Wet Bulb
Temperature (operating):
84° F (29° C)
Shock: 1,500 G/0.5-ms
NOTE:
For solid state disk drives, GB means 1 billion bytes. 16GB is the unformatted capacity of this drive before a portion of the drive is
reserved for flash management features. Actual capacity varies by content and will be less than 15.8GB.
NOTE:
Use of HP System Software Recovery Disks (SSRD) is not supported on 80GB or 128GB SSD models due to minimum image size
requirements (>=140GB) for the SSRD.
QuickSpecs
HP Compaq 8200 Elite Series
Technical Specifications - Solid State Data Storage
DA - 13879 Worldwide — Version 34 — November 26, 2012 Page 48