11. Press the memory cover back in place. Insert the bottom edge of memory cover into the sheet
metal shielding first then press the top edge of memory cover down. Ensure that all the tabs on
the memory cover are pressed firmly against the sheet metal shielding.
Figure 2-7 Replacing the Memory Cover
12. Place the memory access panel on the rear of the computer so that the edge of the panel is
slightly hanging off the edge of the computer and slide the panel toward the center of the
computer until it snaps in place.
Figure 2-8 Replacing the Memory Access Panel
ENWW Removing and Installing Memory 11
To Next Page
Loading...
