1–10 Hardware Reference Guide
Hardware Upgrades
Installing an Expansion Card
✎
When you install an expansion card, make sure you press firmly on
the card so that the entire connector seats properly in the expansion
card socket.
12. Install the screw at the top of the expansion slot to further secure
the part in the chassis.
13. Replace the access panel.
14. Connect external cables to the installed card, if needed.
Reconfigure the computer, if necessary.
Replacing or Upgrading a Drive
The computer supports up to five drives that may be installed in
various configurations.
This Section describes the procedure for replacing or upgrading the
storage drives. A Torx T-15 screwdriver is needed to remove and
install the guide screws on a drive.
To Next Page
Loading...
Need help?
General