CAUTION Regardless of the power-on state, voltage is always present on the system
board as long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the computer.
5. If the computer is on a stand, remove the computer from the stand.
6. Remove the access panel.
7. Locate the correct vacant expansion socket on the system board and the corresponding expansion
slot on the back of the computer chassis.
8. Remove the slot cover retainer that secures the slot covers by lifting the retainer up then out and
away from the chassis.
Figure 2-12 Removing the Expansion Slot Retainer
ENWW Removing or Installing an Expansion Card 21
To Next Page
Loading...
