HP Compaq dc5800

EL-MF877-00 Page 3
Template Revision A
POWER SUPPLY 1:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 11).
3. Remove the power supply PCA from the power supply chassis.
4. Cut two capacitors from the PCA as shown in Figure 11.
POWER SUPPLY 2:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 12).
3. Remove the power supply PCA from the power supply chassis.
4. Cut the small PCA from the large PCA as shown in Figure 12.
5. Cut four capacitors from the large PCA as shown in Figure 12.
POWER SUPPLY 3:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 13).
3. Remove the power supply PCA from the power supply chassis.
4. Cut the small PCA from the large PCA as shown in Figure 13.
5. Cut five capacitors from the large PCA as shown in Figure 13.
POWER SUPPLY 4:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 14).
3. Remove the power supply PCA from the power supply chassis.
4. Cut five capacitors from the PCA as shown in Figure 14.
POWER SUPPLY 5:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 15).
3. Cut five capacitors from the PCA as shown in Figure 15.
POWER SUPPLY 6:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 16).
3. Remove the power supply PCA from the power supply chassis.
4. Cut four capacitors from the PCA as shown in Figure 16.
POWER SUPPLY 7:
1. Using dikes, cut all wires connected to the PCA in the power supply.
2. Remove the three screws that secure the power supply PCA to the chassis (see Figure 17).
3. Remove the power supply PCA from the power supply chassis.
4. Cut the small PCA from the large PCA as shown in Figure .
5. Cut four capacitors from the large PCA as shown in Figure 17.