2–10 Quick Setup & Getting Started Guide
Getting Started
Blank monitor screen.
(continued)
The cable connections are
not correct.
Check the monitor cable connection
from the monitor to the computer to the
appropriate connector, and to the
electrical outlet.
Computer is in Stand By
mode.
Press the power button to resume from
Stand By mode.
The energy saver feature
has been enabled.
Press any key or click the mouse button
and, if set, type your password.
You are using a fixed-sync
monitor and it will not sync
at the resolution chosen.
Make sure that the monitor can accept
the same sweep rate as the resolution
chosen.
The VGA/BNC selector
switch is not properly set.
Set the selector switch to agree with the
cable connection.
Problem Cause Solution
To Next Page
Loading...
Need help?
General