EasyManuals Logo

HP Compaq LA2206xc User Manual

HP Compaq LA2206xc
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
To correct screen position (Horizontal Position or Vertical Position):
1. Press the Menu button on the monitor's front panel to open the OSD Menu, and then select
Image Control > Horizontal Position and/or Vertical Position.
2. Press the + (Plus) or (Minus) buttons on the monitor's front panel to properly adjust the
position of the image in the display area of the monitor. The Horizontal Position shifts the image
left or right; the Vertical Position shifts the image up and down.
Figure 4-4 Horizontal or Vertical Position Adjustment
Using the HP Display Assistant Utility
HP Display Assistant, included on the software and documentation CD, is a software utility that
guides you through the tuning process with easy to understand instructions and background patterns
designed for each monitor control. It provides:
Accurate screen calibration through the use of step-by-step instruction Wizards to obtain the
best overall image quality.
Software control of the monitor image and color settings to eliminate dependence on the
monitor’s front panel buttons and On-Screen Display (OSD) menu.
Defined preset display settings for each individual user in a multi-user environment.
Multiple preset display settings for a single user based on content and ambient lighting.
Asset Management and Power Management capabilities that include remote control for
individual or a group of displays on the domain from a centralized console application.
The HP Display Assistant Utility has two modes of operation: Wizard and OSD mode. The preferred
method of use is Wizard mode, which takes you through a step-by-step process to accurately
calibrate the monitor. This method relies on a sequence of steps that will obtain the best display
results when completed.
NOTE: Refer to the HP Display Assistant user guide for additional information about the software.
Identifying Monitor Conditions
Special messages will appear on the monitor screen when identifying the following monitor
conditions:
Monitor Status—When the monitor is powered on or when the input source signal is changed, a
Monitor Status message is displayed for five seconds. The message shows which input is the
current active signal, the status of the auto-switch source setting (On or Off), the default source
signal, the current preset display resolution, and the recommended preset display resolution.
Input Signal Out of Range—Change resolution setting to 1920 x 1080 – 60Hz—Indicates
the monitor does not support the input signal because the resolution and/or refresh rate are set
higher than the monitor supports.
No Source Signal—Indicates the monitor is not receiving a video signal from the PC on the
monitor video input connector. Check to determine if the PC or input signal source is off or in the
power saving mode.
26 Chapter 4 Operating the Monitor ENWW

Table of Contents

Other manuals for HP Compaq LA2206xc

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq LA2206xc and is the answer not in the manual?

HP Compaq LA2206xc Specifications

General IconGeneral
Screen Size21.5 inches
Resolution1920 x 1080
Panel TypeTN
Aspect Ratio16:9
Brightness250 cd/m²
Contrast Ratio1000:1
Response Time5 ms
Built-in WebcamNo
Dynamic Contrast Ratio1, 000, 000:1
Viewing Angle (Horizontal)170°
Viewing Angle (Vertical)160°
HDCP SupportYes
Built-in SpeakersNo
Height AdjustmentYes
PivotYes
SwivelYes
ConnectivityVGA, DVI

Related product manuals