5–40 Maintenance and Service Guide
Removal and Replacement Procedures
2. Loosen the four Phillips PM2.0×10.0 screws 1 and the
two Phillips PM2.0×13.0 screws 2 that secure the heat sink
to the system board.
3. Remove the heat sink 3 from the base enclosure.
✎
Due to the adhesive quality of the thermal paste located
between the heat sink and processor, it may be necessary
to move the heat sink from side to side to detach the heat sink
from the processor.
Removing the Heat Sink
To Next Page
Loading...
