Optical drives (select models only)
Drives 4–5
Removing an optical disc (without power)
If external or battery power is not available:
1. Insert the end of a paper clip 1 into the release access in the
front bezel of the drive.
2. Press gently until the media tray is released, and then pull out
the tray 2. Remove the disc 3 from the tray by gently
pressing down on the spindle while lifting the outer edges of
the disc. Hold the disc by the edges and avoid touching the
flat surfaces.
✎
If the media tray is not fully accessible, tilt the disc as you
remove it.
3. Close the media tray and place the disc in a protective case.
To Next Page
Loading...
