450C/455CA
430
3–11
Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open
This is the blue on page 3–11 (seq: 81)
This is the black on page 3–11 (seq: 81)
Changing the treatment of overlapping lines
(Merge feature)
The Merge feature provides two alternative settings for the treatment of
overlapping lines in the Setup Sheet:
Merge off.
A subsequent line hides a
previous line where they
overlap.
Merge on.
Overlapping lines and area
fills are merged.
Merge off.
A subsequent line hides a
previous line where they
overlap.
Merge on.
Overlapping lines and area
fills are merged.
You can set this feature from your software in some applications, for example in
AutoCAD.
Localization Note.
PRINT
APPEARANCE
3
Changing the treatment of overlapping lines (Merge feature)
Controlling your print’s appearance
This is the yellow on page 3–11 (seq: 81)
This is the green on page 3–11 (seq: 81)
This is the cyan on page 3–11 (seq: 81)
To Next Page
Loading...