HP Designjet 4500 Series - Page 115

4-23
Service Tests and Utilities
HP Designjet 4500 Printer Series Service Manual
using the Up and Down keys and press Enter to confirm your selection. If
you select No, the printer skips this test and goes to the next one.
39 If you select Yes, the Input Media Driver Multiplexer will start and configure
for Roll 1 Module. If there is a failure at this point, the Front Panel will
display System Error Code 01.0:10. For more information on
troubleshooting this error code, refer to Page 2-3
 Starting BT Arm 1
If there is a failure at this point, the Front Panel will display System Error
Code 56.1:10. For more information on troubleshooting this error code,
refer to Page 2-20.
40 The following message will appear on the Front Panel. Remove the media if
it is still loaded, press any key to continue.
41 The front panel will display the following information:
 Setting BT Arm 1 Zero...
42 A message will appear on the Front Panel asking whether you would like to
run BT Arm 2 and Feed Roller 2 tests with paper. Select Yes or No by using
the Up and Down keys and press Enter to confirm your selection. If you
select No, the printer skips this test and goes to the next one.
43 If you select Yes, The Input Media Driver Multiplexer will start and configure
for Roll 2 Module. If there is a failure at this point, the Front Panel will
Press Enter to
confirm selection
Use UP and
DOWN keys
to select
Press Enter to
confirm selection
Use UP and
DOWN keys
to select