HP Designjet 4500 Series - Page 45

2-15
System Error Codes
HP Designjet 4500 Printer Series Service Manual
System Error: 41:03
Problem
Description:
Electrical current limit in Media-Axis Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Media Drive Test ⇒ Page 4-12.
 Open the Window and check for any visible obstacles restricting the
movement of the Drive Roller. If there is a wrinkled mass of media inside
the paper path, lift the Pinchwheels (using the black Driver Pinch Lever)
and clear the obstruction.
 Replace the Media-Axis Motor ⇒ Page 8-69.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-91.
System Error: 41:10
Problem
Description:
Electrical fault in Media-Axis Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Media Drive Test ⇒ Page 4-12.
 Check that the Media-Axis Motor cable is not damaged and is correctly
connected to the PrintMech PCA.
 Replace the Media-Axis Motor ⇒ Page 8-69.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-91.
System Error: 42:03
Problem
Description:
Electrical current limit in Scan-Axis Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Media Drive Test ⇒ Page 4-12.
 Open the Window and check for any visible obstacles restricting the
movement of the Carriage Assembly. If there is a wrinkled mass of media
blocking the Carriage Assembly, then clear the obstruction.
 Replace the Scan-Axis Motor ⇒ Page 8-66.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-91.