HP Designjet 4500 Series - Page 44

2-14
System Error Codes
HP Designjet 4500 Printer Series Service Manual
System Error: 41.1:10
Problem
Description:
A fault has been detected in the Roll 1 Media Feed Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Media Drive Test ⇒ Page 4-12
 Check that the Roll 1 Media Feed Motor cable is not damaged and is
correctly connected to the PrintMech PCA.
 Replace the Roll 1 Media Feed Motor ⇒ Page 8-158.
 If the System Error continues, replace the PrintMech PCA ⇒ Page 8-91.
System Error: 41.2:03
Problem
Description:
A current limit has been detected in the Roll 2 Media Feed Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Media Drive Test ⇒ Page 4-12
 Open the Roll 2 Drawer and check for any visible obstacles restricting the
movement of the Feed Roller. If there is a wrinkled mass of media inside
the paper path, lift the Pinchwheels (using the Roll 2 Paper Load Lever)
and clear the obstruction.
 Replace the Roll 2 Media Feed Motor ⇒ Page 8-210.
 If the System Error continues, replace the Roll 2 interconnect PCA ⇒ Page
8-230.
System Error: 41.2:10
Problem
Description:
A fault has been detected in the Roll 2 Media Feed Motor.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Media Drive Test ⇒ Page 4-12.
 Check that the Roll 2 Media Feed Motor cable is not damaged and is
correctly connected to the Roll 2 Interconnect PCA.
 Replace the Roll 2 Media Feed Motor ⇒ Page 8-210.
 If the System Error continues, replace the Roll 2 Interconnect PCA ⇒ Page
8-230.