HP Designjet 4500 Series - Page 49

2-19
System Error Codes
HP Designjet 4500 Printer Series Service Manual
System Error: 53.4:10
Problem
Description:
An error with the Roll 2 Media Sensor has been detected.
Corrective Action: Try the following:
 Check that the Roll 2 Sensor cable is not damaged and is correctly
connected to the Interconnect PCA.
 Replace the Roll 2 Media Sensor ⇒ Page 8-232.
System Error: 52:10
Problem
Description:
Drop Detector switch On/Off failure.
Corrective Action: Try the following:
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Check that the Drop Detector cable is not damaged and is correctly
connected to the Service Station cable
.
 Check that the Service Station cable is not damaged and is correctly
connected to the Interconnect PCA
.
 Replace the Drop Detector ⇒ Page 8-38.
 R eplace the Gamut PCI PCA ⇒ Page 8-76.
 If the System Error continues, replace the Interconnect PCA ⇒ Page 8-71.
System Error: 53:10
Problem
Description:
An error with the Main Media Sensor has been detected.
Corrective Action: Try the following:
 Check that the Main Media Sensor cable is not damaged and is
connected correctly to the Interconnect PCA
.
 Perform the Sensors Test ⇒ Page 4-39.
 Replace the Main Media Sensor ⇒ Page 8-115.
System Error:
54:10
Problem
Description:
An error with the Drive Pinch Lever sensor has been detected.
Corrective Action: Try the following:
 Check that the Drive Pinch Lever sensor cable is not damaged and is
connected correctly to the Interconnect PCA
.
 Perform the Sensors Test ⇒ Page 4-39.
 Replace the Drive Pinch Lever sensor ⇒ Page 8-126.