4-55
Service Tests and Utilities
HP Designjet 4500 Printer Series Service Manual
10.3 Others >>> Unit Information
This option allows you to view the following Printer information:
Firmware version.
Serial Number.
Part Number.
PS Language (for HP Designjet 4500PS)
View the Unit Information as follows:
1 In the Service Tests submenu, scroll to "10. Others" and press Enter.
2 In the Others submenu, scroll to "10.3 Unit Information" and press Enter.
3 The Printer will start to initialize and the Front Panel will display the following
messages:
Starting Nvm.
Getting FW version.
Getting Serial Number
Getting Part Number.
If there is a failure at this point, the Front Panel will display System Error
Code 79:03. For more information on troubleshooting this error code, refer
to Page 2-25.
If the Serial Number does not have assigned a correct 10 character format
or the Part number does not have assigned a correct 6 character format, a
fail message will appear on the Front Panel. In this case, re-enter in to the
Service Tests submenu and use the diagnostic "13. Error 71:19 Recovery" to
set the correct Serial Number (refer to Page 4-69).
Getting PS Language (for HP Designjet 4500PS).
If there is a failure at this point, the Front Panel will display System Error
Code 74:00. For more information on troubleshooting this error code, refer
to Page 2-24.
Press Enter
Press Enter
P
HO
N
E
SUP
PO
R
T
To Next Page
Loading...
