4-60
Service Tests and Utilities
HP Designjet 4500 Printer Series Service Manual
10.6 Others >>> Stacker Test
1 In the Service Tests submenu, scroll to "10. Others" and press Enter.
2 In the Others submenu, scroll to "10.6 Stacker Test" and press Enter.
The printer will start to initialize the Stacker Test and the Front Panel will
display the following information:
Starting CDS.
If there is a failure at this point, the Front Panel will display System Error
Code 79:03. For more information on troubleshooting this error code, refer
to Page 2-25.
Getting Part Number
If the Part Number cannot be read, the Front Panel will display System
Error Code 74:00. For more information on troubleshooting this error
code, refer to Page 2-24.
If the Part number does not have assigned a correct 6 character format, a
fail message will appear on the Front Panel. In this case, re-enter in to the
Service Tests submenu and use the diagnostic "13. Error 71:19 Recovery" to
set the correct Part number (refer to Page 4-69).
3 The following message is displayed on the printer, if the Stacker is connected
and turned On, press any key to continue.
Press Enter
Press Enter
P
HO
N
E
SU
P
PO
R
T
To Next Page
Loading...
