HP Designjet 4500 - Page 163

4-71
Service Tests and Utilities
HP Designjet 4500 Printer Series Service Manual
14. I/O Tests
The purpose of this test is to check the installed and active I/O Interfaces.
Perform the I/O tests as follows:
1 Once the message "Ready" is displayed on the front-panel, scroll to the
"Printer Setup Options" icon and press the Enter key.
2 Once inside the "Printer Setup Menus" menu, press the UP or Down arrow
key and the
Cancel key together. You are now in the Service Tools Menu.
3 Use the Arrow keys to scroll to the "Service Tests" menu and press the
Enter key.
4 In the Service Tests submenu, scroll to "I/O Tests" and press Enter.
Press Enter
Press UP
Press Cancel
OR
DOWN
Press Enter
Press Enter
P
HO
N
E
SUP
PO
R
T