HP Designjet 4500

8-40
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Ink Supply Tubes and Trailing Cable
Removal
Switch off the product and remove the power cable.
You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes
and Trailing Cable at the same time. If both parts need to replaced, you MUST
first replace one part and then power ON the Printer until it completely
initializes. Then you can power OFF the Printer and replace the other part.
1. Remove the Right Cover
⇒ Page 8-8 .
2. Remove the Left Cover
⇒ Page 8-11 .
3. Remove the Top Cover
⇒ Page 8-18 .
4. Remove the Rear Door
⇒ Page 8-23.
5. Remove the Right Connector Cover ⇒ Page
8-25
.
6. Disconnect the Trailing Cable from the
Interconnect PCA and the Gamut PCA.
7. Release the two plastic clips securing the
Trailing Cable.