8-84
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
4. Disconnect ALL cables connected to the
Hard Disk Drive.
5. Remove one T-10 screw (Type I) from the
HDD Holder.
6. Slide the Hard Disk Drive upwards and
remove from the Printer.
It is not necessary to remove the
screws securing the HDD inside
the metal casing.
After installing the NEW HDD,
make sure you perform the
following User Calibrations:
Printhead Alignment
.
Paper Advance Calibration
.
Color Calibration
.
After installing the NEW HDD,
make sure you perform the
following Service Utility:
Carriage PCA Setup
⇒
Chapter 4.
You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes
and Trailing Cable at the same time. If both parts need to replaced, you MUST
first replace one part and then power ON the Printer until it completely
initializes. Then you can power OFF the Printer and replace the other part.
1
2
To Next Page
Loading...
