8-96
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Electronics Module
Removal
Switch off the product and remove the power cable.
1. Remove Right Connector Cover
⇒
Page 8-
25
2. Remove Left Connector Cover
⇒
Page 8-26
3. Disconnect ALL the cables connected to the
Interconnect PCA and the Gamut PCI PCA.
4. Remove one ferrite and disconnect ALL the
cables connected to the PrintMech PCA.
5. Remove four T-20 screws (Type B) that
secure the Electronics Module.
To Next Page
Loading...
