8-98
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Back Channel Sensor
Removal
Switch off the product and remove the power cable.
1. Remove Right Connector Cover
⇒
Page 8-
25.
2. Remove Left Connector Cover
⇒
Page 8-
26.
3. Remove Electronics Module
⇒
Page 8-96.
4. Disconnect the cable (BCS) from the Back
Channel Sensor at the rear of the Rear
Path.
5. Unclip the Sensor from the metal bracket at
the rear of the Rear Path.
To Next Page
Loading...
