8-177
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Roll 1 Drawer Sensor
Removal
Switch off the product and remove the power cable.
The procedure shown here is for the Right Roll 1 Drawer sensor, use the same
procedure for the Left Roll 1 Drawer sensor.
1. Remove Roll 1 Module (Front Path)
⇒
Page
8-151
.
2. Remove the Roll 2 Module
⇒
Page 8-190.
3. Remove one screw that secures the Roll 1
Drawer Sensor from below the Rear Path.
4. Remove the Roll 1 Drawer Sensor from
locating pins.
To Next Page
Loading...
