HP Designjet 4500

8-233
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Rear Path
Removal
Switch off the product and remove the power cable.
1. Remove Right Cover
⇒ Page 8-8
2. Remove Left Cover ⇒ Page 8-11
3. Remove Top Cover ⇒ Page 8-18
4. Remove Rear Door ⇒ Page 8-23
5. Remove Right Connector Cover ⇒ Page 8-
25
6. Remove Left Connector Cover ⇒ Page 8-26
7. Remove the Electronics Module ⇒ Page 8-
96
8. Remove Front Panel ⇒ Page 8-27
9. Remove Service Station ⇒ Page 8-30
10. Remove Vacuum Fan ⇒ Page 8-34
11. Remove Ink Supply Station ⇒ Page 8-47
12. Remove Output Platen ⇒ Page 8-104
13. Remove Roll 1 Drawer ⇒ Page 8-142
14. Remove Roll 1 Module (Front Path) ⇒ Page
8-151
15. Remove Roll 2 Module ⇒ Page 8-190
16. Remove two plastic clips securing the
Trailing Cable to the Right Arc.