HP Designjet 4500

8-265
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Media Sensor
Removal
Switch off the product and remove the power cable.
1. Remove the Right Cover
⇒ Page 8-242.
2. Disconnect the cables from the Media
Sensor on the right side of the stacker.
It is very important that when you
reinstall the Media Sensor that
you connect the cables correctly.
The cable marked LS2 is closest to
you, the cable marked LS1 is
closest to the Stacker.
3. Remove two screws that secure the Media
Sensor.
4. Slide the Media Sensor to the right.
LS1
LS2