Paper advance calibration is
recommended.
Press ENTER to calibrate
You are recommended to perform the Advance calibration routine,
to ensure the optimum print quality.
Press the Enter key to create the calibration pattern. See Advance
Calibration.
Paper advance calibration is
recommended. Load paper
and select Paper advance
calibration.
Press ENTER to finish
You are recommended to perform the Advance calibration routine,
to ensure the optimum print quality.
Load a sheet or roll of paper and then select Advance calibration
from the Paper menu. See Advance Calibration
.
Paper loaded with too much
skew
Press ENTER to retry
Press CANCEL to abort
During the loading of paper, the printer has detected that the paper
is skewed too much, that is, it has not been loaded straight enough.
(‘Skew’ is the angle between the actual paper edge and the correct
line.)
Either: Press the Enter key to restart the loading procedure;
Or: Press the Cancel key to cancel paper loading.
Paper mispositioned The paper is not properly positioned in the printer. Either it is out of
the load line margins or it has moved too much from its previous
position.
Reload the paper following the normal procedure, to solve this
problem. See Loading Roll Media
and Loading Sheet Media.
Paper not found
Press ENTER to retry
Press CANCEL to abort
During the loading of paper, the printer has detected that no paper
has been loaded.
Either: Press the Enter key to restart the loading procedure;
Or: Press the Cancel key to cancel paper loading.
Front Panel Messages (continued)
Message Explanation and Action
For more Messages, click on the Next Page button
To Next Page
Loading...