3. Carefully insert the leading edge of the substrate above the black-ribbed roller, making sure the
substrate remains taut during the process. Avoid pulling excess substrate from the roll, which could
cause skew. Also avoid rewinding the substrate manually, unless the printer asks you to do so.
The front panel displays the following.
4. Continue to feed the media until it reaches the printing platen. If the printer is cool. open the window
to help pull the media through. The front panel displays the following.
TIP: If the media you are using has excessive curl, keep feeding the media until the edge is out
of the printer.
5. Pull down the substrate-adjustment lever as far as it will go.
ENWW Load a roll into the printer (manually) 23
Handle the substrate
To Next Page
Loading...
