NOTE: If you want to load the take-up reel during printing, familiarize yourself with the procedural
steps. Loading the take-up reel during printing requires you to complete the procedure while the printer
is feeding and printing substrate. Loading the take-up reel during printing saves approximately 1 m (3
feet) of substrate.
Load a roll onto the take-up reel
1. On the printer's front panel, select the icon, and then select Substrate load > Load take-up
reel.
2. If you want to load the take-up reel now, select Load take-up reel now on the front panel. If you
want to load the take-up reel during printing, select Load it during printing on the front panel.
NOTE: DO NOT use skip check if the skew is above 3 mm/m.
3. Make sure that the loading table is in its upright position.
4. Unlock the take-up reel spindle by pushing the spindle lever to its uppermost position.
ENWW Use the take-up reel 27
Handle the substrate
To Next Page
Loading...
