5. Use the winding button on the take-up reel motor to wind the excess substrate around the take-up
reel spindle.
6. Press the OK button on the front panel.
7. Use the winding button on the take-up reel motor to wind the remainder of the substrate around
the take-up reel spindle.
8. Press the OK button on the front panel.
The amount of printed substrate that is on the take-up reel spindle appears on the front panel.
9. Unlock the take-up reel spindle by pushing the spindle lever to its uppermost position.
ENWW Use the take-up reel 35
Handle the substrate
To Next Page
Loading...
