5. The piece of media will rest on top of the loaded textile media and will fall to floor during the load
process, if this does not occur, simple remove it by hand. Continue to load the media as normal
and adjust the skew accordingly.
View information about the substrate
On the printer's front panel, select the icon, and then select View loaded substrate > View substrate
details.
The following information appears on the front panel:
●
The roll status
●
The substrate family that you have selected
●
The width of the substrate in millimeters (estimated by the printer)
If no substrate is loaded, the message Out of substrate appears.
The same information appears on the Embedded Web Server's Supplies page.
Media Length Tracking Feature
The media length tracking feature enables you to keep track of how much media you have used and
how much is remaining on the roll.
1. When the roll is first loaded onto the printer you have the option to enter the length of media on the
roll. The amount of media that is then subsequently used is then tracked.
38 Chapter 4 Handle the substrate ENWW
Handle the substrate
To Next Page
Loading...
