NOTE: * Unlike other printmodes, 18 pass printmode is 1200 dpi x1200dpi input data resolution at
1bpp (1 bit per pixel). Therefore, to generate a 18pass media preset you should start either from another
existing 18pass or from scratch. In the same way, do not clone a 18pass media preset to generate a
preset with a print mode different from 18pass.
Key
●
Bidir: bidirectional
●
No: not recommended
●
Maybe: may be worth trying for extra speed
●
Yes: recommended
Check the ink quantity of ink on the substrate
Check if the ink quantities in your media preset are adequate. Look at the plot color patches and check
if one or more of the patches have the right ink quantity using the guidelines below:
1. Too much ink: There are several possible symptoms of this problem.
●
The last two or three scales of the plot look the same.
●
Vertical bands.
ENWW Add a new substrate type 45
Handle the substrate
To Next Page
Loading...
